Results 21 to 30 of 36
Thread: oil change
-
10-11-2017, 05:55 AM #21Registered User
- Join Date
- Oct 2017
- Location
- Florida
- Posts
- 60
-
10-11-2017, 01:38 PM #22Registered User
- Join Date
- Oct 2016
- Location
- USA
- Posts
- 159
Yes, but doesn't it depend on what order you do these in? I mean if you started with #8, would #1 and #2 be less amounts? Only way to know for sure would be to open all 8 at once.
-
08-12-2018, 07:19 PM #23Registered User
- Join Date
- Oct 2016
- Location
- USA
- Posts
- 159
Anyone figure out how to reset the service reminder? Doing my oil change myself in a few weeks. Thanks!
-
08-13-2018, 04:54 AM #24Registered User
- Join Date
- Oct 2017
- Location
- Florida
- Posts
- 60
-
08-13-2018, 04:47 PM #25Banned
- Join Date
- Jun 2017
- Location
- USA
- Posts
- 230
You can do it via vag com
Follow this procedure
Prerequisites:
- Time and Date on the vehicle display need to be correct
- Service Reminder on vehicle is active
This is a two step process, follow both steps below:
----------------------------------------------------
1)
[Select]
[17 - Instruments]
[Adaptation - 10]
Enter channel 02
[Read]
The "Stored Value" is the current value for that channel.
Enter the "New" value of [1] (one)
[Test]
[Save]
--> Turn the ignition [Off], wait 10 seconds, ignition [On]
2)
.. Now do this:
----------------
[Select]
[17 - Instruments]
[Adaptation - 10]
Enter channel 02
[Read]
The "Stored Value" is the current value for that channel.
Enter the "New" value of [0] (zero)
--> Turn the ignition [Off], close all doors, lock the vehicle for 1 minute (60 seconds), open the drivers door, ignition [On] and verify the SRI (Service Reminder) is now [off]
-
08-14-2018, 12:29 AM #26Registered User
- Join Date
- Oct 2016
- Location
- USA
- Posts
- 159
Thank you!
-
10-27-2018, 12:56 AM #27Registered User
- Join Date
- Jan 2017
- Location
- Phoenix, AZ
- Posts
- 6
I’ve changed the oil on my Huracan thanks to your post.
How did you get the oil filter element out of the housing without breaking anything? It is a bitch! I had to buy a new housing last time.
-
12-27-2018, 01:04 AM #28Registered User
- Join Date
- Apr 2016
- Location
- Redlands, CA
- Posts
- 44
-
12-27-2018, 01:10 AM #29Registered User
- Join Date
- Apr 2016
- Location
- Redlands, CA
- Posts
- 44
Great posting.... just did my first oil change at 5800 milea....wanted to do it at 3000 but...
Anyway.... Luke your posting said.... drain 1 2 4 5 & 8 are the only ones you need to drain..... it drains 90+ % of the oil.... you don't need to remove any of the under trays either....as these 4 are in plain view.... my next oil change will take 30 min....not 3 hes....I marked the drains bolts with a sharpie..... next time I'll etch it....
I put in 8 qts of oil.... I'm above the line on dip stick but being a sump system....it should not matter.... I can't believe dealer charges 800$ for oil change.... cost $120 in parts....
Btw.... when motor is cold...sat for a few days....does the cold oil level on the dipstick have any relevance??Last edited by jjrho; 12-28-2018 at 12:08 AM. Reason: Typos
-
03-23-2019, 05:14 AM #30Registered User
- Join Date
- Oct 2017
- Location
- Florida
- Posts
- 60
You can use the dipstick when cold to get an idea but the book says to only check it when it’s warmed up.
I just used a vacuum pump and got about 5.5 liters through the oil cap only so that was kind of interesting. You can change the oil filter and pump out more than half the oil without going under the car.
Bookmarks