2 ECU modules need to be replaced..stuck in production mode

[Giallo Orion]

Address : 46 System name : 46 - Conv.system central module with ATA Protocol variant : KWP2000/TP20 ( Ereignisse : 1 )

-Identification:


Hardware part number :
4H0907064ED

Part number :
4H0907064FD

Hardware version number :
H36

Software version number :
0560

Assembly number :

Code :
011E029A18F24081A0B0C80000850347000000000000000000 0000000000

Flash capability :
flashable

System designation :
BCM2 2.0

Target data container :
V03935167QK

Version of the target data container :
0014

Equipment code :
0000000000007011

-Fault memory entries:


Fault memory entry


Number :
VAG03160: Production mode active

Fault type 1 :
tbd

Fault type 2 :
static

[Giallo Orion]

Where are these modules located? And how easy or difficult is this replacement?

[Lambo Mitch]

where are you getting this data and how come the dealer isnt taking care of it? engine ecus are located above rear tires and the other ecus are scattered so depends on what is holding it up.

[Giallo Orion]

where are you getting this data and how come the dealer isnt taking care of it? engine ecus are located above rear tires and the other ecus are scattered so depends on what is holding it up.

i had BCM 1 and BCM 2 replaced at the dealer (parts shipped from the factory) which is VIN specific from the factory to address the above issue. Lambo USA Regional Manager for Tech training supervised the swap. So far so good.